C and C Promotions

PRESENTS

1ST ANNUAL

Southern Indiana Battle of the Bad Boys

MAY 10, 2008 7:00 PM
SCOTT COUNTY FAIRGROUNDS
SCOTTSBURG, INDIANA

GUARANTEED 1ST PLACE $3500.00 (BIG CARS)


$100.00 ENTRY FEE per car

IF MORE THAN 35 CARS all entry fee money will be paid back out among feature cars

MINI CAR HEAT $30.00 ENTRY FEE
(100% PAY BACK WINNER TAKE ALL)

GENERAL ADMISSION
ADULTS $10.00
KIDS 6-12 $3.00 5 AND UNDER FREE

PIT GATES OPEN AT 1:00 PM GRANDSTANDS OPEN AT 5:00 PM

PIT PASSES $20.00

FOR ANSWERS TO QUESTIONS OR CONCERNS OR A COPY OF THE RULES
EMAIL US AT CANDCPROMOTIONS2008@GMAIL.COM

OR CONTACT CHRIS (812) 404-7046 OR CHAD (812) 844-8649

CAR THAT TRAVELS THE MOST MILES OVER 75 MILES WILL GET FREE ENTRY INTO THE DERBY

RAIN DATE MAY 11, 2008 1:00 PM

C AND C PROMOTIONS
PRESENTS
1ST ANNUAL

SOUTHERN INDIANA
BATTLE OF THE BAD BOYS

MAY 10, 2008 7:00 PM
PIT GATES OPEN AT 1:00 PM

SCOTT COUNTY FAIRGROUNDS
SCOTTSBURG, INDIANA


CARS
Cars 1980 and newer only. If running pre-ran car all rules must be met. Any full size or mid size carwill be allowed. No limos, ambulances, 4x4s, el-camenos, or hearse.

MINI CARS
All rules below are for mini cars as well with the following exceptions
Max wheel base of 105 inches allowed
Any make and model car can be ran as long as it is under wheel base standards
4 cylinders and 6 cylinder motors are allowed no v8

CAGES
All cars must have a cage to compete. No tubing larger than 4" x 1/4" in size. Cages are to be built as follows. One door bar per side, one dash bar in place of dash, dash bar can not be more than 3" past the front inside door seem, one bar behind driver seat not to be more than 12" behind door post, uprights are to be attached to bar behind seat and not to extend to the frame of the car and are to be at least 4" above the roof line of car. Cross bar can run across roof to tie uprights together. Uprights are mandatory. Cage is not to be welded to the frame anywhere on the car, if cage touches frame anywhere car will not be allowed to compete, cage is also
not to go past fire wall.

DOORS AND TRUNKS
Doors and trunks can be welded solid. No steel plates wider than 3" and no thicker than 1/4" will be allowed to weld seems. Door straps can not go past rocker panels. Rear of trunk lids can be tucked down inside of trunk and welded solid, all other parts of trunk must remain stock. Trunk lids must have a 12" x 12" hole cut in lid for inspection. (THIS IS MANDATORY) No all-thread allowed in trunk. There is no smashing, ball pinging, wedging, rolling, folding, or pinching of trunks, fenders, or quarter panels allowed.

FRAMES
Frame seems may be welded top and bottom no thicker than 1/4" and no wider than 3/8" will be allowed. This will be measured and strictly enforced. All factory holes on frame must remain open, DO NOT fill in any holes on frame. Only the outside of the humps on the rear of car frame may be plated with 1/4" thick and no more than 22" long steel, and must conform to the shape of the frame and not go past humps in either direction. No other plating on frame allowed. Frames may be pitched.

HOODS
No half hoods allowed. The hoods can only be wired down in four spots and no wire directly in front of the radiator. Washers no larger than 2" and no thicker than 1/4" may be used. A 12" x 12" hole must be in hood for fire safety. Hoods must be open for inspection.


BODY MOUNTS
The body mounts can be removed. Body bolts must remain in stock position but can be replaced with a bolt no bigger than 1/2". Washers can be used to bolt body and frame together, washers can be no bigger than 3" round or square and no thicker than 1/4". Bolts and washers must fit inside frame in factory body mount holes. Cars may have ONE extra body mount per side of frame.

BUMPERS
The bumpers can be welded solid to the frame. Bumpers must appear stock. Only car bumpers may be used. Bumper height can be no higher than 22" and no lower than 17" from bottom of bumper to ground (front and rear bumpers) this will be measured and strictly enforced.

BATTERY
Battery must be moved to inside of car and strapped or bolted securely down. Two batteries may be used. Batteries must be covered during competition with a non flammable item.

GAS TANKS
Original gas tank must be removed. The tank must be placed behind driver. Nothing larger than a 6 gallon tank will be allowed. The tank must be mounted solid in car. No gas tank protectors allowed in cars!!!

ENGINE
Engines can be replaced and any engine can be ran in any car. No diesel engines allowed. If chains are used to hold motors down you are only allowed 2 per side of engine, one in front and one in back of motor and are not to be welded to the frame. Distributor protectors are allowed, but can not touch the frame or cage, and if it does the car will not be allowed to compete. Radiators must remain in stock position and only one radiator allowed. No carborator protectors allowed.

TIRES AND WHEELS
Open tire rule. No studded tires and screwing tires to rims. No valve stem protectors allowed. No split rims. All wheel weights must be removed from rims.

SUSPENSION AND REAR ENDS
The suspension can be solid. No coil to leaf conversion and no leaf to coil conversion allowed. If rnning a leaf spring car no addding of leafs allowed No truck rear ends. Rear end can be welded for positive traction. Ball joint stops can be no more than 2" x 2" square and no thicker than 1/4". Tie rod ends may be reinforced.


INSPECTORS HAVE FINAL DECISION ON ALL RULES
FOR QUESTIONS OR INFO CONTACT
CHRIS (812) 404-7046 OR CHAD (812) 844-8649

( RICKY RONE WROTE)Is this the first show for the NAPA series? Rules look great , I can't wait to get started building.

( C & C Promotions Wrote )no this is not we are a seperat promotion team that is putting on a derby in indiana and we are trying to get as many people to come to it as possiable i seen this site and added our derby here
we are guaranteing first place money 3500$$$ and hope u and all ur buddes come to are derby if u have any questions feel free to call me or email me thanks

thanks mike for moving are post sorry if i confused anyone

u all are more than welcome to run are derby

i just wanted to let everyone know we(derbytees)will be set up at this big derby.we have lots of new designs for you for this year.be sure to come by the booth and pick something up and just say hi.we love meeting everyone.also i wanted to let you all know we will have a great looking event shirt for this derby for those of you who love and collect the derby event shirts.you will only be able to get this one the day of the derby so come by the booth early before they are sold out.there will be a limited number available.thanks again to c & c promotions and hope to see you there.
paul/derbytees